MALCO TurboXTools™ DH Door Hemming Drill Attachment, # M53455

MALCO TurboXTools™ DH Door Hemming Drill Attachment, # M53455

Attachment, delivery without drill!

Efficiently hem the edges of replacement door skins for passenger vehicle and light trucks with limited manual “tacking” requirements. The drive shaft of this power-assisted Turbo-X-Tool DH Hemming attachment inserts into the chuck of a minimum 14.4 Volt cordless or maximum 7 Amp A/C drill. A telescoping clamp adjusts to fit length and width of any drill housing. Optional spacers are included with clamp. The clamp collar allows the shear head to rotated 360° and can be set in any position for optimum tool clearance when navigating profiles and to facilitate easy material flow.

The installed Hemming attachment is easily operated with one hand. Remove the old door skin and prep the door as usual. Slightly angling the upright lip of the replacement door skin with a hammer and dolly and flattening the point of entry will ensure smooth operation. For best results, keep the anvil of the Hemming tool flush against the outer edge and finished side of the door skin. The high impact, ABS polymer anvil will not scratch or mar the replacement door skin. A narrow seaming wheel fits flush against the anvil fence to provide a tight, clean hemmed door edge. The Malco DH Hemming Tool attachment is resistant to solvents and is easily cleaned of the adhesive used between the door skin and panel.

• Hem door skins with speed and precision
• Will not mar or scratch door skin finish
• Resistant to solvents
• Safe, controlled operation

• Drill Requirements: Min 1/4 in (6.35mm) Chuck, Min 14.4 V-DC/Max 7 A-AC 

   

• SPECIFICATIONS

  Catalog #	Description	Hemming Capacity ga. (mm)	Weight lbs. (kg)
  DHT1	Hemming, Drill Attachment	20 (0.91)	3 (1.36)